SG90 4.8V~6V 9g Micro Servo Motor RC for Robot Helicopter Airplane Controls for DIY with limit switch

Specification:Model: SG90Weight: 9gStall torque: 1.8kg/cmOperating speed: 0.1sec/60degreeOperating voltage: 4.8VTemperature range: 0℃ ~ +55℃Dead band width: 10usMaximum rotation angle: 180 degreesGear medium: nylonWorking mode: SimulationCircuit connection:Yellow line (signal line)Red line (power line)Brown (ground)Package includes:10* SG90 9g Micro Servos

How to connect SG90 micro servo motor to Arduino Uno?

The connection with Arduino is extremely easy. The servo has three leads. The brown one is the Ground so connect to it Arduino Ground.

The red one is VCC which usually requires a voltage between four points eight to seven point two volts. So connect it to Arduino 5V.

The last lead, the orange one is the control signal which needs to be a PWM signal with a periodic time of twenty milliseconds aka 50 Hertz

and a duty cycle of one to two milliseconds so five to ten percent.

While an on time of one millisecond represents the -90° position of the motor shafts, one point five milliseconds represent 0° position and

two milliseconds the plus 90° position. That means you can rotate the shaft a total of 180°.