We extend our warmest wishes to you and your family for a joyous Dipawali and a blessed Chhath. May these festivals bring light, prosperity, and happiness into your lives.
VNH2SP30-Monster Moto Shield 30A Stepper Motor Driver Module
₨ 1,000.00
In stock
Description
Description:
This is essentially a ramped-up version of our Ardumoto motor driver shield. For this monster shield, we’ve replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. We’ve also beefed up the support circuitry so this board is capable of driving a pair of high-current motors! The VIN and motor out are pitched for our 5mm screw terminals (not included), making it easy to connect larger gauge wires. (This is a Single Chip)
Note:When using this board in extreme high-demand applications it may be necessary to improve thermal performance with a heat-sink or fan and to solder the wires directly to the board instead of using a screw terminal (in addition to the myriad other complications present in a high-current system) However, when using the board at currents up to 6A the chips will barely become noticeably warm.
Specification:
Driver Model
Monster Moto Shield VNH2SP30
Operating Voltage
12 ~ 16V DC
Peak Current
30A
Continuous Current
14A
No. of Channels
1
Over-Current Protection (A)
Yes
Thermal Protection
Yes
LED Indicator
Yes
Cooling Fan
No
Arduino Sheild
No- can be used with Wire connection
Features:
- Current sensing available to Arduino analogue pin
- MOSFET on-resistance: 19 mΩ (per leg)
- Maximum PWM frequency: 20 kHz
- Thermal Shutdown
- Undervoltage and Overvoltage shutdown.
Package Included:
1 x 30A Mini VNH2SP30 Stepper Motor Driver Monster Moto Shield Module
